Royal Sovereign RSL-2702S Owner's Manual download pdf (Page 17)

RSL-2702S

17

12. TROUBLESHOOTING

Symptom Cause Possible Solution

Machine will not turn on:

a. Power switch is in "0"

(Off) position

b. Tripped circuit breaker.

c. Blown main power fuse.

a. Put the power switch to

the "I" (On) position

b. Reset the circuit breaker.

c. Replace the fuse.

There is power, but the

rollers are not turning after

the "RUN" button is pressed:

a. Safety cover is not closed.

b. Front table is not installed

correctly.

c. Blown motor fuse.

a. Close the safety cover to

active the safety switch.

b. Properly install the Front

table so that the micro

switch is activated.

c. Replace the motor fuse.

The unit is not heating up

a. The machine is in "COLD"

mode.

b. Set temperature is lower

than the room

temperature.

a. Switch to "HOT" mode.

b. Raise the temperature

according to the

recommended film

temperature.

Curled lamination:

a. Upward curl.

b. Downward curl.

a. Loosen the top roll film

tension.

b. Loosen the bottom roll

film tension.

Unclear lamination:

The hot roller temperatures

are too low and/or lamination

speed is too fast.

Raise the roller

temperatures and/or lower

the lamination speed.

1 2 ... 12 13 14 15 16 17 18 19 20

Comments to this Manuals

No comments