RSC-LS/LSH SERIES LaminatorsOWNER'S MANUALRoyal Sovereign International Inc.www.royalsovereign.comRead all instructions carefully before use. F
9910. LOADING FILMRoyal Sovereign films are wound with the adhesive side facing the inside of the roll (adhesive in).Loading films to upper and lower
RSC-LS/LSH SERIES 1011. THREADING FILMFigure 1Figure 211.1. Decaling1. Turn the power switch on (“I” position). The Power switch is locate
11Figure 39. Cut and separate the release liner and the film. (Figure 3)10. Thread the craft paper behind the Lower Idle Bar to the top film tha
12RSC-LS/LSH SERIES Figure 11. Lay the decaled image face down on a flat surface. Carefully peel back and put a crease along the edge of the rele
13Installation of the Front Feeder Option (Includes 2 brackets, one spindle, and mounting hardware).1. Install the Front Feeder to the inside of the
14RSC-LS/LSH SERIES 13. MAINTENANCE 14. TROUBLESHOOTINGCleaning the Body of the laminator1.To clean the machine body, dampen a cloth with water
15 15. SPECIFICATIONS DESCRIPTION RSC-880LS/LSH RSC-1120LS/LSH RSC-1400LS/LSH RSC-1650LS/LSH Power supply AC100,200 220~240 5
16 16. WARRANTYRoyal Sovereign International warrants the equipment sold is free from defects in material and workmanship for a period
1TABLE OF CONTENTSTOPIC PAGE1. Introduction ...
RSC-LS/LSH SERIES 2 1. INTRODUCTION2. SAFETY PRECAUTIONSFailure to comply with any of the following safety procedures could result in serious in
3 3. INSTALLATIONNote: The laminator should be installed by a trained service technician.ELECTRICAL REQUIREMENTSThe laminator comes fully assembled,
RSC-LS/LSH SERIES 4 4. INCLUDED WITH LAMINATORThoroughly inspect the parts and the unit. It is imperative that any missing parts are reported an
5 5. PRODUCT IDENTIFICATION8912113476510NO PART NAME RSC-LS/RSC-LSH1 EMERGENCY SWITCH O2 FEED TABLE O3 MAIN ROLLER O4 ASSEMBLY STAND O5 FOOT PEDAL O6
RSC-LS/LSH SERIES 6. CONTROL PANELWhen the machine is initially turned on, the LED display window will show the speed and temperature set at 1.
77. ROLLER NIP SETTINGIt is important to adjust the roller nip settings to the appropriate thickness of the board being used. Use the guide below to
RSC-LS/LSH SERIES 89. USING CROSS CUTTERFigure 1Figure 2Figure 3The cross cutter is located on the rear exit table of the machine.1. After lamin
Comments to this Manuals