RSL- 2702S LaminatorOWNER'S MANUALRead all instructions carefully before use. For any Customer Support needs please choose the Customer Suppo
107. CONTROL OF ROLLER PRESSURETo set, pull the pressure lever outward and turn to one of the following positions. OPEN: For detaching and cleanin
RSL-2702S118. CONTROL PANEL1. UPPER: To change upper roller temperature by pressing button, then up or down arrow. (range 32~302°F or 0~150°C)2.
121. Turn on the power switch located on the rear of the machine.2. Set the pressure lever to the "Laminating mode".3. Adjust the roller te
RSL-2702S13— Useful Information — 1. You can preset up to 9 temperature and speed settings in the memory for faster easier use.2. When laminating co
149.2. COLD LAMINATING1. Thread the cold film in accordance with the illustration and instructions 6.2 on page 8.2. Set pressure lever to the proper
RSL-2702S159.3. MOUNTINGFigure 11. Set the laminator to cold by pressing the c/hot button.2. Lay the decaled image face down on a flat surface. Caref
16Cleaning the Body of the laminatorTo clean the machine body, dampen a cloth with water only and gently wipe the machine clean.Removing Adhesive Buil
RSL-2702S1712. TROUBLESHOOTINGSymptom Cause Possible SolutionMachine will not turn on:a. Power switch is in "0" (Off) positionb. Tripped ci
1813. Recommended Temperature and Speed Settings14. Factory presetFilm thickness Temp RemarkOpp film 32 micron (1.3 mil) 110°C (230°F) 1 - 3Opp film 3
RSL-2702S1915. SPECIFICATIONSDescription RSL-2702SPower supply AC 110V / 60HzPower consumption 1500WMax. laminating width 685mm / 27"wFilm thickn
2TABLE OF CONTENTSTOPIC PAGE1. Introduction ········································································································
20RS International Australia PTY. LTD.30 Prime Drive, Seven Hills, NSW 2147, AustraliaTEL : +61) 2-9674-2127 FAX : +61) 2-9674-2027E-mail : sal
RSL-2702S3 1. INTRODUCTION2. SAFETY PRECAUTIONSFailure to comply with any of the following safety procedures could result in serious injury. Please
4 3. INCLUDED WITH LAMINATOR4. PRODUCT IDENTIFICATIONPower supply:220V~240VPower supply:100V~120VPART NAME EA REMARK PART NAME EA REMARK FUSE(65T
RSL-2702S55. LOADING FILM1. As shown in picture 1, insert auto grips onto the upper/lower film shaft.2. As shown in picture 2, using the special too
66. THREADING FILM1. Turn the power switch on("I" position). Power switch is located in the rear of the unit on the left side.2. Complete
RSL-2702S78. Carefully pull up the laminate from the lower roll up towards the first idle bar and then around the back side of the second Idler (Cau
81. Follow the steps in the "Loading Film" procedure by loading the upper shaft with pressure sensitive film, e.g. (Royal Print-Pro Film) a
RSL-2702S91. Turn the power switch on("I" position). Power switch is located in the rear of the unit on the left side.2. Follow the steps
Comments to this Manuals