RSC-1401C/H SERIES LaminatorsOWNER'S MANUALRoyal Sovereign International Inc.www.royalsovereign.comRead all instructions carefully before use.
9910. LOADING FILMRoyal Sovereign films are wound with the adhesive side facing the inside of the roll (adhesive in).Loading films to upper and lower
RSC-1401C/H SERIES 1011. THREADING FILMFigure 1Figure 211.1. Decaling1. Turn the power switch on (“I” position). The Power switch i
11Figure 39. Cut and separate the release liner and the film. (Figure 3)10. Thread the craft paper behind the Lower Idle Bar to the top film tha
12RSC-1401C/H SERIES Figure 11. Lay the decaled image face down on a flat surface. Carefully peel back and put a crease along the edge of the rel
13Installation of the Front Feeder Option (Includes 2 brackets, one spindle, and mounting hardware).1. Install the Front Feeder to the inside of the
14RSC-1401C/H SERIES 13. MAINTENANCE 14. TROUBLESHOOTINGCleaning the Body of the laminator1.To clean the machine body, dampen a cloth with wate
15 15. SPECIFICATIONS DESCRIPTION RSC-880LS/LSH RSC-1120LS/LSH RSC-1401C/H RSC-1650LS/LSH Power supply AC100,200 220~240 50/6
16 16. WARRANTYRoyal Sovereign International warrants the equipment sold is free from defects in material and workmanship for a perio
1TABLE OF CONTENTSTOPIC PAGE1. Introduction ...
RSC-1401C/H SERIES 2 1. INTRODUCTION2. SAFETY PRECAUTIONSFailure to comply with any of the following safety procedures could result in serious i
3 3. INSTALLATIONNote: The laminator should be installed by a trained service technician.ELECTRICAL REQUIREMENTSThe laminator comes fully assembled,
RSC-1401C/H SERIES 4 4. INCLUDED WITH LAMINATORThoroughly inspect the parts and the unit. It is imperative that any missing parts are reported a
5 5. PRODUCT IDENTIFICATION8912113476510NO PART NAME1 EMERGENCY SWITCH O2 FEED TABLE O3 MAIN ROLLER O4 ASSEMBLY STAND O5 FOOT PEDAL O6 TENSION CONTRO
RSC-1401C/H SERIES 6. CONTROL PANELWhen the machine is initially turned on, the LED display window will show the speed and temperature set at 1.
77. ROLLER NIP SETTINGIt is important to adjust the roller nip settings to the appropriate thickness of the board being used. Use the guide below to
RSC-1401C/H SERIES 89. USING CROSS CUTTERFigure 1Figure 2Figure 3The cross cutter is located on the rear exit table of the machine.1. After lami
Comments to this Manuals