Royal Sovereign RSL-2702S Owner's Manual download pdf (Page 16)

Cleaning the Body of the laminator

To clean the machine body, dampen a cloth with water only and gently wipe the

machine clean.

Removing Adhesive Build Up

1. Remove the film from the laminator.

2. Use a hard rubber block(crepe rubber or sandpaper belt disc cleaning block)

3. Rub firmly but do not scrub the roller vigorously as this may cause scratch the

surface.

4. Do not use any sharp objects, steel, wool or abrasive, as these may damage the

rollers

NOTE: Adhesive removes easily when hot. When changing laminating film is an ideal

time to clean the rollers. Please use caution when cleaning hot rollers.

11. MAINTENANCE

10. USING CROSS CUTTER

1. After lamination, move the cutter approximately to the center of the completed

application at the desired point of detachment (Figure 1).

2. Grasp film with one hand, press the cutter downward into the application and slide it

first to one end of the application, then to the other end to complete the cut

(Figure 2 & 3).

Figure 1

Figure 2

Figure 3

The cross cutter is located on the rear exit table of the machine.

1 2 ... 11 12 13 14 15 16 17 18 19 20

No comments

Royal Sovereign RSL-2702S Owner's Manual Page 16