Royal Sovereign RSH-380 Owner's Manual download pdf (Page 4)

RSH-380

6. FILM LOADING & THREADING

< Film Threading >

1. Turn the power switch on (“I” position). (The Power

switch is located on the rear the unit)

2. Complete the steps in the "Loading Film" section.

3. Set the desired temperature.

4. Remove the Front Feed Table.

5. Pull down the upper film over the Safety cover to the

lower film; align and center the lower film to the

upper film and tighten the 2 lower bolt core

screws. (Figure 1)

6. Rewind the upper film until it aligns with the safety cover.

7. Thread the film over the Lower Idle Bar and underneath

the safety cover until the film rests on the upper

roller. Figure 2

8. Put the Front Feed Table back on and close the Safety

cover. Figure 3

9. Press the Run button and thread the film using the

Laminating Threading Card. Figure 4

< Thermal Film Loading & Threading >

Loading Film

1. Remove the upper and lower film shafts from the

machine and load the films (do not tighten the

core screws at this time)

2. To load the top film, insert 1" core as shown on

Figure 1 (Note the direction that the film is wound)

3. Insert the shaft as shown in Figure 2.

Figure 1

Figure 2

Figure 1

Figure 2

Figure 3

Figure 4

Figure 3

Figure 4

Figure 5

4. Insert the core plug on the left hand side. (Figure 3)

5. Align and center the film and tighten the two core

screws. (Figure 4)

6. Repeat steps 2 through 4 to load the lower film.

(Please note the direction that the film is wound

for the bottom roll). (Figure 5)

7. Load the upper and lower film shafts on the machine.

1 2 3 4 5 6 7

Comments to this Manuals

No comments

Royal Sovereign RSH-380 Owner's Manual Page 4

Comments to this Manuals

Related products and manuals for Laminators Royal Sovereign RSH-380