Royal Sovereign RSL- 2702S Owner's Manual download pdf (Page 6)

6. THREADING FILM

1. Turn the power switch on("I" position). Power switch

is located in the rear of the unit on the left side.

2. Complete the "Loading Film" steps as shown on

page 4.

3. Set the temperature and speed according to the

Recommended Temperature and Speed section.

4. Remove the Front Table.

5. Pull down the upper film over the Safety Cover to

the lower film; align and center the lower film to

upper film (Picture 1).

6. Rewind the upper film until the film aligns with the

Safety Cover.

7. Thread the film over the Upper Idle Bar and

underneath the Safety Cover until the film rests on

the upper roller (Picture 2).

UPPER ROLL FILM

ADHESIVE SIDE

UPPER IDLE BAR

ROLL

ADHESIVE SIDE

LOWER ROLL FILM

FIRST IDLE BAR

SECOND IDLE BAR

GLOSSY SIDE

Picture 2

Picture 1

6.1. HOT FILM

1 2 3 4 5 6 7 8 9 10 11 ... 19 20

No comments

Royal Sovereign RSL- 2702S Owner's Manual Page 6