Royal Sovereign RSL-2701 Owner's Manual download pdf (Page 13)

TABLE TOP LAMINATOR

9. MAINTENANCE

1. Do not apply any cleaning fluids to the rollers certain fluids may cause damage.

2. Do not clean rollers with sharp or pointed objects.

3. Use a crepe rubber cleaning block to remove adhesive from rollers. Works best when rollers are hot.

4. Use a damp cloth with water to clean the body of the machine.

5. Store machine in a dry clean area.

1. Turn the laminator ON (I) located on the rear of the machine. (Fig. 2)

2. Choose appropriate laminating temperature and speed. (Fig. 1)

3. Do not begin laminating until the blinking light is steady (approximately 8 minutes).

4. Position the item to be laminated on the feed table.

5. Press the RUN button. The rollers will begin to turn, and feed the item into the machine.

6. Insure the machine drastically cold, press the button in the left cover be “ O ”,then you can laminate by upper

roller for single laminating.(It is a damage for the paper to laminate by single side while the rollers up and low are

heating all together.)

- Model applies RSL-2701S only for USA.

7. The first paper is bad while OPP film laminating, please use a test paper first and then the second paper must

keep the distance less than 15mm form the front one.

- Model applies RSL-2701S only for USA.

8. Stop the laminator when all of the items have completely exited the rear of the machine.

9. Adjust top + botton roll feed tension until lamination is flat.

(See film tension adjustment page 8.)

NOTE: Stand by mode and auto power off mode

- Stand by mode: If no activity is made within 30 minutes after each use the machine will automatically switch

into stand by mode. (In stand-by mode the temperature will decrease to 80~90°C and the three

temperature setting indicators will blink).

- Auto power off mode: If the machine is in stand by mode and no activity is made for 60 minutes the

machine will automatically power off.

- If any activity is made while in stand by or auto power off mode the machine will return to it’s previous

stage.

8. OPERATION INSTRUCTIONS

1 2 ... 8 9 10 11 12 13 14 15 16

No comments

Royal Sovereign RSL-2701 Owner's Manual Page 13