Royal-sovereign RSH 380SL User Manual download pdf (Page 7)

Desk

Top

RSH-SERIES

8. Carefully pull up the laminate from the lower roll up

towards the first idle bar and then around the back

side of the second Idler (Caution: lower roller may

be hot).(Picture 3)

9. Tack the lower film to the upper film that is resting

on the main hot rollers (Picture 4).

10. Reinstall the Front Table and close the Safety

Cover.

11. Adjust the nip setting to 1/4'' (6mm).

12. Insert and push the leader board into the hot

rollers (Picture 5).

13. Adjust the nip setting to "Laminating" mode.

14. Push the Run button.

15. Press the Run button and adjust the supply roll

tension knobs by rotating clockwise or

counterclockwise. Turn it until the supply roll

films have some resistance (the tension

varies depending on the film thickness; the

thicker the film the more tension is required)

(Picture 6).

16. Press Stop button when the leader board has

completely exited the rear of the unit.

17. Use the Cross Cutter to cut the leader board from

the web (see page 18).

18. Peel Trim any excess film off of the leader board

edges. The leader board can be reused.

19. Set the roller nip setting to the appropriate position

for the lamination or encapsulation application.

Picture 3

Picture 4

Picture 5

Picture 6

1 2 3 4 5 6 7 8 9 10 11 12 ... 15 16

No comments

Royal-sovereign RSH 380SL User Manual Page 7