Royal-sovereign RSH 380SL User Manual download pdf (Page 6)

6. THREADING FILM

6.1.

HOT

FILM

DOUBLE SIDED

LAMINA

TING

UPPER ROLL FILM

ADHESIVE SIDE

IDLE BAR

LAMINATING HOTROLLERS

GLOSSY SIDE

PULL ROLLERS

ADHESIVE SIDE

LOWER ROLL FILM

IDLE BAR

GLOSSY SIDE

1. Turn the power switch on ("I" position). Power switch is located

in the rear of the unit on the left side.

2. Turn on the lower hot roller by pressing S/D

button on the control panel. This button will be lit

when the lower heat is on.

3. Complete the "Loading Film" steps as shown on

page 4.

4. Set the temperature and speed according to the

Recommended Temperature and Speed section.

5. Remove the Front Table.

6. Pull down the upper film over the Safety Cover to

the lower film; align and center the lower film to

upper film (Picture 1).

7. Rewind the upper film until the film aligns with the

Safety Cover.

8. Thread the film under the Upper Idle Bar and

underneath the Safety Cover until the film rests on

the upper roller (Picture 2).

Picture 1

Picture 2

1 2 3 4 5 6 7 8 9 10 11 ... 15 16

No comments

Royal-sovereign RSH 380SL User Manual Page 6