Bucketless Dehumidier
BDH-450, BDH-550
Box Contents:
• Dehumidier should have at least 12 inches of space on all sides for good circulation.
• Keep all doors and windows closed in the area the dehumidifier is located.
• Keep the unit away from sources of dirt, dust, or any woodworking equipment.
Auto-Pump
1. First, place the included hose clamp over the
drainage hose.
2. Push the drainage hose over the auto-pump
drainage hose outlet until it is secure.
3. Push the hose clamp over the outlet to
secure the hose.
4. Put the draining end of the hose over any
suitable area where water can be emptied:
a sink (A), drain (B), or window (C).
QUICK SETUP GUIDE
Manual Draining
1. Take out the rubber stopper on the manual drain outlet.
2. Position the manual drain outlet directly above
oor drain if possible. If not, use ½ inch diameter
hose to drain into a place lower than the unit.
• The auto-pump system on this dehumidifier is designed to
start pumping water out of the internal reservoir when the
water level reaches the half-full level. Water can be pumped
vertically up to 10 feet.
• Or, you can use the manual drain outlet, if you have a floor drain
that is at a lower point than the unit, so water drains by gravity.
Note: Auto-pump will not operate if manual drain is set up.
BDH-450
control panel
A B C
SETUP
DRAINING OPTIONS
OPERATION
A
u
t
o
-
p
u
m
p
d
r
a
i
n
a
g
e
h
o
s
e
Storage hooks
for hose and
power cord
Manual drain outlet
(hose not included)
Auto-pump
drainage hose outlet
Hose clamp
Hose protector (for use with windows)
1. Press power button to start.
2. Using - and + buttons, select desired humidity level.
• This dehumidifier allows 30-80 percent
humidity level.
3. Press the fan button to adjust fan speed.
1.
2.
3.
4.
1.
2.
3.
4.
Indicator Lights
Water light will turn on if water is restricted from exiting the unit.
Defrost light will turn on if room temperature is below 40° F.
See user manual for troubleshooting.
User manual
Dehumidier Auto-pump drainage hose
• Be sure water flows away from buildings or other objects that
could be damaged.
• The draining hose must not be put more than 10 feet above
the floor on which the unit is standing.
1. First, put an
11
/16 inch diameter hose clamp over the hose.
2. Then push the hose over the manual drain outlet.
3. Then push the clamp over the outlet to secure the hose.
4. Put the draining end of the hose over a drain or suitable
place for water to empty.
• Manual drain hose and
11
/16 inch diameter hose
clamp not included. A ½ inch diameter hose and
11
/16 inch diameter hose clamp should be used if necessary.
• If there is a steel or plastic tip
on your ½ inch diameter hose,
it should be removed.
Installing a ½ inch diameter hose:
+
-
(48 pages)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comments to this Manuals