Royal Sovereign RSH-1151 Owner's Manual download pdf (Page 7)

RSH-1151/1651

1211

12. LOADING FILM 13. THREADING FILM

Royal Sovereign films are wound with the adhesive side facing the inside of the roll

(adhesive in).

Loading films to upper and lower film shafts:

(See page 5 for assistance with parts identification.)

1. Adjust the auto grip to fit to the film and tighten the

auto grip screw (Figure 1 & 2).

2. Remove the upper and lower film shafts from the

machine and load the films (Center the upper and

lower films on the shaft). Note the direction of the

adhesives on the lower and upper films

(Figure 3 & 4).

3. Load the upper and lower film shafts on the

machine (Figure 5 & 6).

Figure 1

Figure 2

Figure 3

Figure 1

Figure 2

Figure 3

Figure 4

Figure 6

Figure 5

13.1 Lamination and Encapsulation

Thermal Lamination

1. Turn the power switch on (“I” position). Power switch is

located in the rear of the unit on the left side.

2. Complete the steps on “Loading films to upper and

lower film shafts” - Page 11

3. Set the rollers temperature to the recommended film

temperature.

4. Take off the Paper Guide and the Front Table.

5. Pull down the upper film over the Safety Cover to the

lower film; align and center the lower film to upper film

(Figure 1).

6. Rewind the upper film back until the film aligns with the

Safety Cover.

7. Thread the film over the Upper Idle Bar and underneath

the Safety Cover until the film rests on the upper roller

(Figure 2).

8. Carefully pull up the laminate from the lower roll around

the back side of the lower idler (Caution: lower roller may

be hot).

9. Tack the lower film to the upper film that is resting on the

main roller (Figure 3).

1 2 3 4 5 6 7 8 9 10

Comments to this Manuals

No comments

Royal Sovereign RSH-1151 Owner's Manual Page 7

Comments to this Manuals

Related products and manuals for Laminators Royal Sovereign RSH-1151