Royal Sovereign NB-1900N Owner's Manual download pdf (Page 10)

**You can laminate photographs or pictures on a mounting board,

less than 2mm (1/12") thick without any tension adjustment.**

1. Press the power button to turn the machine on.

2. Set FOIL setting with

3. When the LED light stops blinking and buzzer rings, the laminator is ready.

4. Place material on Mounting board.

5. Insert Mounting board squarely into opening slot.

6. Finished Mounting board will exit through rear of machine.

7. When you are finished laminating, press the power button to turn machine off.

* When you do laminating several colors, use high temperature tape

to hold color foils in place.

1. Unplug the machine and unscrew the 8 screws on bottom of laminator,

set machine upright and lift off the cover.

2. Locate each end of left and right pressure spring on the upper part as shown.

3. Reassemble top cover with 8 retaining screws and do lamination.

* For general lamination, set pressure springs to lower position.

NB-1900N

MOUNTING BOARD LAMINATING

* The document, which has been mounting board laminated, is

pretty hot and easily bent. Try not to touch the document until

it has cooled down.

* When laminating to mounting board, pressure adjustment is

needed for good quality lamination.

'***USEFUL INFORMATION***

'***LAMINATION PRESSURE ADJUSTMENT***

•

1 2 ... 5 6 7 8 9 10 11 12 13 14

No comments

Royal Sovereign NB-1900N Owner's Manual Page 10