Royal Sovereign RET Series Owner's Manual

RET SeriesOWNER'S MANUALRoyal Sovereign International Inc.www.royalsovereign.comRead all instructions carefully before use. For any Customer Sup

RET Series107. Position the main trimmer assembly on top of the floor stand. And properly align the bolt holes. Use bolts (M8x55) to attach the main

RET Series115. OPERATIONThe trimmer must only be used by trained and qualified personnel. The trimmer must be used only for trimming material for w

RET Series126. MAINTENANCEStandard maintenanceCAUTION: Unplug the trimmer from the power outlet during any maintenance to avoid risk of electric sho

RET Series137. TROUBLESHOOTINGSymptoms Cause Possible SolutionMachine won't turn on. Lamp is off, and main switch is off positiona. Power cord

RET Series148. SPECIFICATIONS9.1 Technical informationMODEL RET-1501 RET-2001 RET-2501Power supply 100V(50/60Hz), 110~120V(60Hz), 220V(60Hz), 220~24

RET Series15 9. WARRANTYRoyal Sovereign International warrants the equipment sold is free from defects in material and workmanship for a period of On

RET Series2TABLE OF CONTENTSTOPIC PAGE1. INTRODUCTION

RET Series3 1. INTRODUCTION2. SAFETY PRECAUTIONSThank you for choosing a Royal Sovereign trimmer. It has been designed and manufactured to provide y

RET Series4Dangerous areas and residual risksAll the areas around the machine in which people are at risk of injuries or health problems are considere

RET Series53. PRODUCT IDENTIFICATION978121110534612NO PART NAME1 Left Side Cover2 Power Switch3 Feed Table Front4 Fabric Holder Rod5 Protection Plate

RET Series64. INSTALLATIONNote: The trimmer should be installed by a trained service technicianThe trimmer needs to be assembled by a trained install

RET Series74.2 Box contentsThoroughly inspect the parts and the unit. It is imperative that any missing parts are reported and a claim is filed with

RET Series84.3 Assembly1. Open the box carton and remove all parts. 2. Open the tool-box. (Fig. 4-1)This operation must be carried out by a minimum of

RET Series95. Slide the holder rods into the adjacent holes of the assembly in accordance with Fig. 4-4. Using pinchers, place the E-rings into the a