RSL-2701U (for CANADA MODEL)RSL-2701S (for USA MODEL )OWNER'S MANUALRead all instructions carefully before use. For any Customer Support needs
103. Insert one of the core adapters into the right end of the film core. For film with poly-in (adhesive side is inside the web), make sure the adhe
TABLE TOP LAMINATOR11LOADING LOWER ROLL FILM1. Repeat steps 1-5 to load the lower roll film.2. Once the upper and lower film is on the shaft, pull th
12LAMINATING SINGLE SIDED (RSL-2701S USA Model only)Press the switch into the location “SINGLE ”. Figure 13
TABLE TOP LAMINATOR139. MAINTENANCE1. Do not apply any cleaning fluids to the rollers certain fluids may cause damage.2. Do not clean rollers with sh
1410.TROUBLE SHOOTING GUIDESymptom Cause Possible SolutionRollers do not operate after the RUN/STOP button is pressed1.Safety cover is opened2. Power
TABLE TOP LAMINATOR1511. SPECIFICATIONSMODEL RSL-2701U RSL-2701S RSL-2701 RSL-2701S RSL-380SPower supply AC120V 60HzAC100V 60Hz AC220~240V 50/60HzAC
16 11. WARRANTYRS INTERNATIONAL AUSTRALIA PTY. LTD.30 Prime Drive, Seven Hills, NSW 2147, AustraliaTEL : +61) 2-9674-2127 FAX : +61) 2-9674-20
2TABLE OF CONTENTSTOPIC PAGE1. Introduction ...
TABLE TOP LAMINATOR3 1. INTRODUCTION2. PACKAGE CONTENTSThank you for purchasing the Table Top Laminator. It has been designed and manufactured to pr
43. SAFETY PRECAUTIONSFailure to comply with any of the following safety procedures could result in serious injury. Please read the instructions care
TABLE TOP LAMINATOR54. PARTS1. Upper Film 2. Lower Film 3. Idle Bar4. Hot Rollers 5. Feed Table 6. Paper Guide7. Contro
65. CONTROL PANELFilm Application Temperature210~230 ˚FFilm Application Temperature230 ~270 ˚FFilm Application Temperature270 ~310 ˚F210 ~230 ˚F230 ~
TABLE TOP LAMINATOR7Film Application Thickness125mic(100~125mic)125mic* (100~125mic)Film Application Thickness50~100mic(50~75mic)50~100mic* (50~75mic)
8Power Switch 1 Located on the rear of the machine. “I” (on) “0” (off). (Fig. 2)Cross Cutter 2 Used to cut off the laminated web. (Fig. 2)Feed Guide 3
TABLE TOP LAMINATOR9Figure 7Figure 87. FILM LOADING & THREADINGFigure 61. Slightly slide the upper film shaft to the right and pull it out from t
Comments to this Manuals